 |
|||
|
CMT Chute |
|||
Low Volume Loader
|
|
CMT Chute • Add on to your existing trailers with two simple assemblies!
|
|
|
|
|
 |
|
|
A full 180-degree swing is perfect! |
A simple slide-on, slide-off installation! |
At only 40 pounds this non-stick plastic makes clean up and transport easy! |
|
 |
Two Simple Assemblies. 1. Mounting Assembly |
1. Chute Assembly The mounting assembly stays with each trailer. The chute assembly can move between trailers |
|
 |
2. Slide the mounting assembly over the rear tilt frame support and center on the drum opening. Order a mounting assembly for every trailer in your fleet. |
2. Slide the square tube opening over the round pivot bar on the chute and pin into place. |
|
 |
3. Insert the tube spacer behind the frame and push the bolt from the bottom. Tighten with washers and nut. |
Add Chute assemblies as your demand increases... 3. The Chute assembly slides on and off the square tune of the mounting assembly. Align and pin together. |
|
| Company Information | Contact Us | Call a Cart-Away Expert. 1-800-909-9809 | |||
